LD947 Material
Management System
CONSIDER THE POSSIBILITIES
- Improve machine productivity
- Confirm the accuracy of information
originating from other sources in a plant, such as weighbridges or
production machinery
- Identify excessive machine
down-time
- Help identify material shrinkage
- Eliminate cost of manual
transcription of data
- Cross check invoicing to a customer
or billing from a supplier
- Identify peak loading patterns to
determine machine and operator scheduling
- Schedule machine maintenance based
on workload
- Manage product inventory
The possibilities are endless...
LOADRITE - THE TOOL
FOR INCREASING YOUR PROFITS
In a typical
operation, the loader driver will "plug-in" the Data Module to
the Loadrite Weigh indicator at the beginning of the shift. The module
remains there until the end of the shift and is then returned to the
office where the data can be "up-loaded" using the Material
Management System (MMS) software. Reports can then be run to determine
total production, etc. Once "up-loaded", the module is ready
for use again. The data is automatically saved on the computer's hard
disk.
The MMS
software enables a variety of reports to be generated so that the
payload data can easily be displayed and analyzed. for further
data analysis or manipulation, reports can be printed or exported to
Microsoft Word© or Excel©. Note: all payload data is stored in an
Access© database.
Technical
information
Data Memory Module
Memory
Capacity
250kByte (4000 to 12000 lifts depending on configuration of weigh
indicator)
Ambient
Temperature
Operating: -10ºC to +50ºC (14ºF to 122ºF)
Storage: -30ºC to +70ºC (22ºF to 176ºF)
Protection
IP54 (Data module protected equivalent to IP68)
Computer
Minimum requirements for running Loadrite MMS Software:
Pentium 166 with Windows 95 or Windows 98 or Windows NT
Available com port
CD ROM drive
50MB free hard disk space (more may be required if database becomes
large.)
